QUALITY AND IMPROVEMENT OF BEARING CAPACITY OF SANDY SOIL BY GROUTING
The
construction of structure on weak ground often requires the soil to be improved
in order to ensure the safety and the stability of surrounding buildings. The
ground improvement in granular soils can be achieved by different methods such
as vibro-floatation, compaction piles, and compaction with explosives,
excavation and replacement, grouting e.t.c. The selective of the most suitable
method depend on a variety of factors, such as: soil conditions, required
degree of compaction, types of structure to be supported, as well as site
specific considerations available time for completion of the project,
availability of equipment and materials e.t.c. Soil compaction can offer
effective solutions for many foundation problems and his especially useful for
reducing total settlement in sand. Sandy soil means
most of the soil particles are bigger than 2mm in diameter. It gives good water
drainage and has a low capacity to hold nutrients. Sandy soil does
not hold moisture very well. It is granular and consists of rock and mineral
particle that are very small. Therefore, the texture is gritty and is formed by
the disintegration and weathering of rocks such as limestone, granite, quartz
and shale. Is also easier to cultivate it if it is rich in organic materials
but then it allows drainage more than needed. This results in over drainage and
dehydration of the plant in summer. It warms very fast in the spring season.
Grouting on the other hand is a process whereby stabilizes either in the form
of suspension or solution is injected into sub surface soil. Sandy soil is the
largest particle in the soil when you rub it, if feels rough. This is because
it has sharp edges and it does not hold many nutrients.
HISTORICAL BACKGROUND OF GROUTING
The
development and history of compaction grouting over the last 30-40 years as
been established by many distinguished researcher, design engineer and design
contractor. Many technical papers are been published dealing physically with
the issues surround compaction grouting design such as: “compaction grouting,
1973”, “planning and performing compaction grouting” 1974. These and other
important reference are the main stream basis of knowledge for the highly
specialize engineering and construction technique know as compaction grouting.
The compaction grout method as some unique features which allow distinct
advantages over other remedial method of geo-technical construction. In many
distances growth is the only viable solution. Some of the advantages include:
Economic: Many time compaction grouting is the only feasible solution to
foundation settlement problems, other than demolishing the structure and
re-building with expensive deep foundation technique. Minimal disturbance:
During the grouting operation, destructure may remain occupied and in service.
Minimal risk: Compaction grouting offers minimal risk of catastrophic
structural failure while re-leveling structure. Other are: Minimal geotechnical
exploration, provide greater support for structures, cost factor e.t.c.
AIM AND OBJECTIVE To determine the nature
of the sandy soil
particles. To determine the degree of the sandy soil
compatibility. To carry out the improvement of sandy soil
through grouting. To carryout some laboratory test on sandy soil such
as compaction test California bearing ration (CBR) test, atterberg LIMIT test,
liquid limit test, Plastic limit test, sieve analysis test in comparing the
effectiveness of grouting system.
SCOPE OF THE STUDY
This
research is focused on the quality and
improvement of bearing capacity of sandy soil by grouting.
LIMITATIONS OF THE STUDY
The
limitations of this study are: TIME
FACTOR: Limited time that does not permit to carryout many practical.AREA OF STUDY: This project is limited the
technical study of sandy soil
properties.
Comments
Post a Comment